This is because it is in high temperature protection mode.
Bitmain power supply fan.
If gauge is too low it will not power the supply only the fan within.
Replace the faulty power supply 3.
Check whether the fan is spinning or not.
The bitmain power supply works well for us residents.
95 105 v a c.
This power supply is an upgraded version of apw3 and it has few technology advantages compared to our apw3.
Power factor 0 95 full load leakage current 1 5 ma 220 v 50 hz protection low voltage input.
Re plug the line 2.
View return policy.
Psu repeatedly stops for a few seconds then resumes.
80 89 v a c.
2 x 12038 fan over voltage protection.
Plug 6 pin 12v plugs from the bitmain power supply to the 8 positions on the hash boards and the one position on the control board.
View return policy 6 976 00.
Then plug in the power supply to the outlet pigtail.
There are a total of 10 plugs coming from the power supply so there will be one extra unused plug.
Cannot scan the miner.
Power off protection trip time 9 ms.
Check if power supply s output has been short circuited or overloaded.
Power off the psu for 10 minutes then resume.
Plug in the ethernet cable to the antminer.
5 pairs of 6 pin pcie connectors 10 connectors noise level 43 db input voltage range.
1 check whether the power supply and power cables are plugged in and powered 2 measure with a multimeter for whether the power supply 6pin line has 12v output 3 check the control board and the hashboard for burnout marks.
I have 16 miners of all types the bitmain psu s are great.
In stock new antminer s9 13 5t bitcoin miner asic btc bitmain mining machine with power supply.
2 rear fans size.
Yes over load protection.
I highly recommend using a higher gauge power cord with it especially if using it to power a s9 t9 a3 or d3 220 volts.
This would cause the power supply to the protection mode.
2 x 12038 fan.
This power cable works great.
Apw7 is a new power supply model released by bitmain especially for our antminers.
Replace the control board.
100 240 v a c.